cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1102
Views
3
Helpful
20
Replies

Unable to Access Web Server - Whats Wrong with this Configuration

mfdarvesh
Level 1
Level 1

ASA working in IPSec, I am able to access HQ from UNIT No problem. Internet is only allowed on specific IPs which are outside DHCP Scope. When I assign IP for internet, now Internet is working, HQ Network is accessible, but S_EXT (webserver - 10.10.10.111) don't work. Unable to understand why it is working when internet is OFF. Here is configuration - What's wrong pl

ASA Version 9.1(1)
!
interface GigabitEthernet0/0
description ****WAN-INTERFACE****
nameif outside
security-level 0
ip address 203.x.x.x 255.255.255.252
!
interface GigabitEthernet0/1
description ****LAN-INTERFACE****
nameif inside
security-level 100
ip address 192.168.135.1 255.255.255.0
!
ftp mode passive
object network OBJ_ANY
subnet 0.0.0.0 0.0.0.0
object network S_INTERNET
range 192.168.135.230 192.168.135.240
object network S_UNIT
subnet 192.168.135.0 255.255.255.0
object network HQ
subnet 192.168.100.0 255.255.255.0
object network S_EXT
host 10.10.10.111
access-list 100 extended permit ip object S_UNIT object HQ
access-list 100 extended permit ip object S_UNIT object S_EXT
access-list OUTSIDE extended permit icmp any any echo
pager lines 24
mtu outside 1500
mtu inside 1500
no failover
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
nat (inside,outside) source static S_UNIT S_UNIT destination static HQ HQ
nat (inside,outside) source static S_EXT S_EXT destination static HQ HQ
!
object network S_INTERNET
nat (inside,outside) dynamic interface
access-group OUTSIDE in interface outside
route outside 0.0.0.0 0.0.0.0 203.x.x.x 1
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication ssh console LOCAL
http server enable
no snmp-server location
no snmp-server contact
crypto ipsec ikev1 transform-set MYSET esp-3des esp-md5-hmac
crypto ipsec security-association pmtu-aging infinite
crypto map VPNMAP 20 match address 100
crypto map VPNMAP 20 set peer x.x.x.x
crypto map VPNMAP 20 set ikev1 transform-set MYSET
crypto map VPNMAP interface outside
crypto ca trustpool policy
crypto ikev1 enable outside
crypto ikev1 policy 1
authentication pre-share
encryption
hash md5
group 2
lifetime 86400
telnet timeout 5
dhcpd dns 8.8.8.8
!
dhcpd address 192.168.135.50-192.168.135.200 inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
tunnel-group x.x.x.x type ipsec-l2l
tunnel-group x.x.x.x ipsec-attributes
ikev1 pre-shared-key *****
!
class-map inspection_default
match default-inspection-traffic
class-map default
!
policy-map type inspect dns migrated_dns_map_1
parameters
: end

20 Replies 20

Yes friend but are ASAbranches have two ISP or one?

MHM


@MHM Cisco World wrote:

Yes friend but are ASAbranches have two ISP or one?

MHM


Yes, both are on different locations and using separate ISPs

Not that what I am meaning' what I meant is are each site connect to two or more ISP or only single ISP?

MHM

Each Side -->> Single ISP only

MatthewW98
Level 1
Level 1

I don't see it in your config but don't you need to allow specifically http with "http x.x.x.x x.x.x.x inside/outside" command?


@MatthewW98 wrote:

I don't see it in your config but don't you need to allow specifically http with "http x.x.x.x x.x.x.x inside/outside" command?


Yes - it is specifically covered in HQ Config 

Review Cisco Networking for a $25 gift card