06-21-2007 10:24 PM - edited 03-03-2019 05:33 PM
i telnet 2620XM and unable to connect, when i login to console its show
" Low on memory; try again later" what to do i am not able to connect both by telnet and console.
need urgent reply
thanx & Regds
Naveed
06-21-2007 11:22 PM
Hi,
Please reload the router and then try to reconnect to it.
HTH,
Mohammed Mahmoud.
06-22-2007 09:23 AM
Naveed
The message Low on memory; try again later indicates that there is not enough memory to support creation of an exec process for telnet. It is probably the result of some bug or a memory leak in the code that you are running. I believe that Mohammed is correct that a reload of the router is the short term solution. It will reclaim lost memory and allow you to telnet. In the long term you need to determine why the amount of available memory decreased. Probably the long term solution will be an upgrade of the code that you are running.
HTH
Rick
06-23-2007 12:05 AM
Hi,
Totally agree with Rick, a code upgrade solves the problem most of the times.
HTH,
Mohammed Mahmoud.
06-25-2007 12:07 AM
mohammed solution is temporarily, i do the same and my problem solved, i have 12.2(15)T14 IOS installed in my router 2620XM. please advised how much the IOS required memory or should i upgrade it. during reboot i didnt find any error regarding memory.
thanks for reponse
06-25-2007 01:16 AM
Hi Ahmed,
As Rick has pointed out before, this incident is most probably the result of some bug or a memory leak in the code that you are running, and thus you can run into it again, and thus you are strongly recommended to upgrade your code.
HTH,
Mohammed Mahmoud.
06-22-2007 10:44 AM
reload the router on rmon.
check the flash image file and change it with the one that can be used with capactiy of ram and flash you have.
disable unwanted services if you do not want to change IOS
or else check for memory leak issue.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide