01-10-2008 07:57 PM - edited 03-03-2019 08:13 PM
I am able to log in to my routers from LAN-
However when i vpn, I am unable to get even a response from a branch router. I can log into other routers at different sites. For some reason though, I get no response from the 4 IP addresses configured on the
interfaces for this particular router
I am able to log into a switch that is direclty connected to it-
And i attempt to telnet through that switch, but i get a "password,required but not set" response. I do have username/pw and login local configured on the vty lines.
does this make sense?
01-10-2008 08:34 PM
HI, [PLS RATE if HELPS]
Refer Link below for Help:
Kindly check whether you have followed the procedure as said in above link in configuring the password for Telnet Users.
PLS RATE if HELPS
Best Regards,
Guru Prasad R
01-11-2008 03:52 AM
i have configured
username xxxx privilege 1 password xxxx
enable password xxxx
.
.
.
.
line vty 0 4
login local
any ideas?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide