09-20-2013 05:43 PM - edited 03-04-2019 09:06 PM
Dear Friends,
Can you any one help me to resolved the below attached topology.
I have three router connected back to back R4-R5-R7, R7 loopback address in reflecting in R4 routing table but I am unable to ping router R7 L1 200.200.200.1,100.100.100.5 from R4 or R7 to R4.
Kindly help me to resolve the issue.
I am attaching the sh run and log with Diagram.
Regards,
Prasad
09-20-2013 06:09 PM
Hi Prasad,
You only advertise the loopback address, therefore you need to use the loopback address as the source address when you ping from one peer to the other. You can do that with extend ping.
Regards
09-21-2013 05:04 PM
Dear Harold,
Thanks for your reply, now I am able to ping the one peer to others through source loopback.
But is it possible the ping the router without using source address in BGP if yes then help to shorted out.
Thanks
Regards,
Prasad
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide