We have a lab network set up with a 7609 router as the central core. Scenario: Laptop with a SIP client. In the lab is a session border controller that will route signaling and media to a SIP gateway with a call agent (172.23.112.201) and a media "handler" (172.23.113.6). The call processing device will forward packets to an RF network (108.x.x.x) where an NCS cable modem sits.
Call signaling works perfectly fine. However, RTP traffic from the laptop to the NCS phone is getting routed incorrectly. RTP traffic from the phone to the laptop works fine.
Expected traffic patterns:
Laptop to phone: Orange + Blue in picture below. Laptop > corporate router > 7609 > SBC > 7609 > SIP Gateway > 7609 > CMTS > MTA > Phone.
Phone to laptop: Green in picture below. Phone > MTA > CMTS > 7609 > SIP Gateway > 7609 > SBC > 7609 > corporate router > Laptop.
Packet captures show the laptop to phone RTP packets are being routed back towards the corporate router. These time out with ICMP TTL exceeded packets. There are static routes for 172.23.113.0/27 to the optical interfaces that go to the SIP gateway. Interestingly, I can ping an IP on the SIP gateway (not used for media, but is pingable) in that static range (172.23.113.1) just fine from the 7609 (i.e. it's not getting routed to the corporate router). Unfortunately, the IP for the media endpoint on the SIP gateway is not pingable. Config for the 7609 is attached.
Any thoughts? Questions I have concerning the config are with the "ip source-route" entry as well as the mls & cef entries.
Cisco DNA Center
What's new in Cisco DNA Center 2.1.2
Cisco DNA Center 2.1.2.x Features and Capabilities
Cisco DNA Center -Intent Based Networki...
A major international airport is looking to build a cutting-edge new terminal, designed to run 24/7 with no interruptions. With the airport always on round the clock, a critical component required to support this is the surveillance infrastructure, which ...
Dear expert,I am facing an issue which you may come across before. Grateful if you would teach me how to do it.I have a Cisco WS-C3650-24TS switch in MZ which I would like to configure so that on the GigabitEthernet1 / 0/1 portis configured with VLAN 100,...
Hi AllWe are looking at some new switches for our top of racks in our DC.We have looked at the 9300 series UX models with the big buffers which is classed as a high scale model.I have tried to look at some Nexus models for top of rack, but there appears t...