i am configuring my Cisco 1841 following this guide:
http://www.cisco.com/en/US/tech/tk827/tk369/technologies_configuration_example09186a00801e51e2.shtml
The ruoter opens the tunnel and my clients see LOCAL IP ROUTER. All my LAN components can't see
anything.
Is it a NAT Problem or Routing Problem ?
vpdn-group 2
! Default PPTP VPDN group
accept-dialin
protocol pptp
virtual-template 2
l2tp tunnel receive-window 1024
interface Virtual-Template2
ip unnumbered FastEthernet0/1
peer default ip address pool test
no keepalive
ppp authentication chap ms-chap pap
!
ip nat pool NPOOL 88.38.192.2XX 88.38.192.2XX netmask 255.255.255.248
ip nat inside source list 110 pool NPOOL overload
!
access-list 110 permit ip 192.168.126.0 0.0.0.255 any
ip local pool test 192.168.126.227
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Serial0/0/0.1