Routing

Dear all experts,Thanks in advance.I am confused about selcting the best path from One ISP as the primary and the second ISP as the secondary.In Topology IGP = EIGRP and EGP = BGP.BGP routes are redistributed in EIGRP.From CORE how can I tune the pat...

Hey,How can I reinstall cisco connect on my computer?I was doing a Cisco Connect update on my laptop when I shut it down by accidentWhen I opened the laptop again Cisco Connect was no where to be found in the computer.Does anyone know how I can fix t...

Hi - I have a situation where I have to use EIGRP to advertise a /24 (1.1.1.0/24) out router A to the WAN while some specific devices on that network (1.1.1.123/32, 1.1.1.234/32) have to be advertised out router B to the same WAN. Any ideas on how to...

Hi All,My understanding is that each CBWFQ class in a policy-map has a default output queue depth of 64, which is also the MAXIMUM queue depth.However, if this is the case, how can the following WRED command be referring to a max threshold value of 1...

Hi all,I was troubleshooting a faulty DSL interface when I found some error in my 'show dsl int atm 0' command. I got the following output:FEC ES Errors:    0                               0ES Errors:            0                               1SES E...

This is a simple question but I tried searching and could not find an appropriate answers. Can the experts please help me. Thanks.Basically we have the following:1) ADSL Broadband Internet line PPoE with a Static IP2) Cisco Router 8703) Zyxel Firewal...

Hi all,I would like to know how much Voice bandwidth are assigned in my router.Following are the partial command from router.Router Apolicy-map MAP class voice    priority 200interface Serial0/0/0.1 point-to-point bandwidth 1024 frame-relay interface...

I have setup of 2 servers on 2 different PEs and work as a redundant .IF S1 becomes down ,S2 comes up with the same IP address of S1 .how can i configure that setup so that all the network can reach the 2 servers when any of them is up .I thought abo...

Hi,we are migrating dns server from our ISP to our own box. please advise what steps should be taken to accomplish this?

We have Cisco router 3825,Due to increasing demand of ethernet interface, recently we added one Hwic-2 fasthenet module. But we are not able use both port of same module, When we connect both port simultaneously then one of the port became hanged.As ...

Hi all,I configured PBR at C4507R-E.  When user goes to internet, it match with access-list 181, and traffic should be go to "set ip next hop". But traffic doesn't go to set ip next hop, it send to default route. I configured access-list, route map a...