09-13-2010 12:50 AM - edited 03-04-2019 09:45 AM
Dear all
Cisco 1841 router with VWIC-1MFT-G703 card , old cards getting error , so we planned replace new VWIC-1MFT-G703 , its detecting but line protocol was down , than we changed another cards also same status ,
Physical loop given ( PIn out 1 and 4 2 and 5 ) , both cards show line protocol up ( looped)
Please suggest any modification required in configuration side , Slot 0 ( OLD card ) Slot 1 - New Card
WIC/HWIC Slot 0:
E1 G703 (1 port) Multi-Flex Trunk WAN daughter card
Hardware revision 1.0 Board revision A0
Serial number 36621247 Part number 800-06722-04
Version Identifier V02 FRU Part Number VWIC-1MFT-G703
Test history 0x0 RMA number 00-00-00
Connector type PCI
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 2F 01 00 02 2E CB BF 50 1A 42 04 00 00 00 00
0x30: 50 00 00 00 08 08 18 00 FF FF FF FF FF FF FF FF
WIC/HWIC Slot 1:
E1 G703 (1 port) Multi-Flex Trunk WAN daughter card
Hardware revision 1.0 Board revision E0
Serial number 33597427 Part number 800-06722-02
FRU Part Number VWIC-1MFT-G703=
Test history 0x0 RMA number 00-00-00
Connector type PCI
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 2F 01 00 02 00 A7 F3 50 1A 42 02 00 00 00 00
0x30: 70 00 00 00 05 05 26 00 FF FF FF FF FF FF FF FF
09-13-2010 01:58 AM
Hi Siva,
Have you tried in another slot?
It does not look like hardware issue.
The following troubleshooting guide for FR may help you out....
http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml
Regards...
-Ashok.
09-13-2010 02:17 AM
Hi,
we tried three new card same status , 3 card are view in show diag command , but line protocol down , same slot Old is working with errors.
Physical loop -- > it Line Protocol UP ,, ( after remove the Frame-relay encapsulation ) ,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide