Routing

HiI'm looking for Cisco documentation with best practice guidlines on how to setup a new POP connecting into an existing MPLS network using OSPF and IBGP in the AS.Regards,Werner le Grange

I am looking for suggestions to help me understand why I'm seeing a high rate of fan failures on my routers. I manage 1500 routers, comprising 2821, 2851 & 3845. In the last 7 months, nearly 4% of these routers have exhibited a fan failure and I thin...

Hi Folks,I need a  little help, how do I nat from outside to inside? I need to allow connection to my outside ip address from SIP provider and then pass it to the sip server which has a private/internal.Thank you in advanced I appreciate it.JP

hi,I've created 2 sub interfaces and connected links on that. But i'm unable to get statistics on those sub interfacescan someone help me on this..thanks.... S

Hi,I have a Cisco 2651XM router with two built in FE interfaces. Please, I just wanted to know if I could add another FE interface.Listed below if the router details:cisco 2651XM (MPC860P) processor (revision 0x200) with 125952K/5120K bytes of memory...

Hello Dears,      I have the following situation on a router. I have a mail relay agent(10.0.0.5) and I have to translate port 25 of my global address x.x.x.x:25 to it. The mail relay agent sends the received mail to the mail server which has the add...

Hello EveryoneI am looking to reduce the % of b/w utilization of outbound traffic if it uses the following ports:3600137-139If possible, I would like to set the rule for a specific server: 192.168.17.39Can this can be done through QoS policy map?  If...

i have 14 acces points and 65 destops ( windows xp ) and 14 laptos ( mac ) , I tried to do upgrade in my security , wep - wpa2 personal , but when i do the upgrade the wpa2 dont work in mac computers , wahts is wrong with this , canot conect or is so...

Ping frome r1:r1#ping 10.100.12.2 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.100.12.2, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 4/7/8 msr1#and show access-list on r2:r2#sh ac...

Dear all,I have a Cisco C857 router and i am unable to use the track command. is there any thing need to be done I tried and upgraded the router and checked still the command is not available. I can see only advance security software in the image sel...

Hi all,I am newbie on Cisco and now self learning on it, hope can pass the CCNA, I have a 1812J Router right now.And it have 128M Ram with 32M CF Card. And I have the adventerprisek9 IOS image, but it said need 256M RAM with 64M CF then can using it ...

Dear Member,We want to configure bandwidth mangement on 3750 . there are number of vlans on 3750.Can it possible by QOS ?pls suggestThanks