Hi, I have the 2 port VWIC card and one of the ports is always detecting slips seconds and errored seconds when the clock is on line, I think may be I must change the card but I don't know if there's a buf related to that.
Model 1841
flash:c1841-spservicesk9-mz.124-17.bin
Card
WIC/HWIC Slot 0:
E1 (2 port) Multi-Flex Trunk (Drop&Insert) WAN daughter card
Hardware revision 1.0 Board revision B0
Serial number 30199770 Part number 800-04615-03
FRU Part Number VWIC-2MFT-E1-DI=
Test history 0x0 RMA number 00-00-00
Connector type PCI
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 25 01 00 01 CC CF DA 50 12 07 03 00 00 00 00
0x30: 58 00 00 00 03 03 12 00 FF FF FF FF FF FF FF FF
config
!
controller E1 0/0/1
channel-group 1 timeslots 1-31
!
!
State
E1 0/0/1 is up.
Applique type is Channelized E1 - balanced
No alarms detected.
alarm-trigger is not set
Version info Firmware: 20070320, FPGA: 20, spm_count = 0
Framing is CRC4, Line Code is HDB3, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (301 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
301 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
301 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 1 15 minute intervals):
0 Line Code Violations, 0 Path Code Violations,
900 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
900 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
CS_BGP001M0#
Thank's in advance
Regards