Wake On LAN help

[kartik.shah1]

Hi,

I am not able to turn on workstation using wake-on-lan utility in case when magic packet is sent from different vlan.

But same workstation gets turned on if magic packet is sent from same vlan.

I am using open source utility -  'mc-wol.exe'.

For both scenario i have captured packet using wireshark. Wireshark results shows that workstation is receiving magic packet in both cases.

Please find attachment showing wireshark capture.

Please provide proper guidance for above issues. 

[Mark Malone]

Hi
what way have you set the Cisco switch it needs the helper on the vlan and directed broadcast setup for the vlan is that in place ?

see this guide
https://www.symantec.com/connect/articles/configuring-wol-deployment-solution-cisco-environment

[kartik.shah1]

Hi Mark Malone,

I have configure ip-helper on vlan interface Cisco 6000 series switch. Moreover i have another Cisco switch between workstation & core Cisco 6000  series switch.

[Mark Malone]

Hi

shouldn't matter once the switch is layer 2 inbetween workstation and 6k

have you set the directed broadcast as well under the vlan interface and the forward protocol in the global config  , can you post your config just for the wol setup from 6k vlan