05-11-2015 05:56 PM - edited 03-05-2019 01:26 AM
Hello guys.
I have two Routers (2801, 2811)
I changed the confreg-register from 0x2102 to 0x2132 by my mistake.
But it is not working properly.
When I connected to the routers with PC, in the PuTTY, its font was broken down.
So, I searched it and then I found that the answer was to be setting the console speed more than 9600.
I did following that steps.
However, I recognized another problem was present...
After I configured register 0x2102, but It was changed 0x2122...
Continuously I changed register, but continuously remained 0x2122.
The point is .. Why did it change continuously 0x2122???
Please teach me what can I do to fix it!
Regards,
Solved! Go to Solution.
05-11-2015 06:02 PM
Eject the CF from the router(s). Reboot the router into ROMmon. Change the config-registry value to the correct ones from ROMmon: config-register 0x2102.
Once done, insert the CF and reboot the router once more.
05-11-2015 06:47 PM
Glad to see it's working.
May I ask if you can mark this thread as "Answered"?
05-11-2015 06:02 PM
Eject the CF from the router(s). Reboot the router into ROMmon. Change the config-registry value to the correct ones from ROMmon: config-register 0x2102.
Once done, insert the CF and reboot the router once more.
05-11-2015 06:30 PM
05-11-2015 06:32 PM
AHAHAHAH
You're Right !!
I finally completed this problem !
Thank you so much~^^
05-11-2015 06:47 PM
Glad to see it's working.
May I ask if you can mark this thread as "Answered"?
05-11-2015 07:38 PM
OK I just clicked ^^!
I ask you to reply my another question...
https://supportforums.cisco.com/discussion/12504576/i-also-have-problem-about-cisco-2801
plz show!!ㅠ_ㅠ
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide