cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1477
Views
0
Helpful
3
Replies

What command can be used to see RD value in peer PE in MPLS?

wfqk
Level 5
Level 5

Hi Here a topology, PE1 and PE2 have different RD value as the below in MPLS. From PE2, what command can be used to see routes which are from PE1 and are attached by RD 100:1? Thank you

PE1
vrf abc
RD 100:1

PE2
vrf abc
RD 100:2

1 Accepted Solution

Accepted Solutions

Francesco Molino
VIP Alumni
VIP Alumni

Hi

You can use the command:

Sh ip bgp vpnv4 rd xx:xx

Take a look on this link:

http://www.cisco.com/c/en/us/td/docs/ios/iproute_bgp/command/reference/irg_book/irg_bgp5.html#wp1163912

Thanks 

PS: Please don't forget to rate and mark as correct answer if this answered your question.


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

View solution in original post

3 Replies 3

Francesco Molino
VIP Alumni
VIP Alumni

Hi

You can use the command:

Sh ip bgp vpnv4 rd xx:xx

Take a look on this link:

http://www.cisco.com/c/en/us/td/docs/ios/iproute_bgp/command/reference/irg_book/irg_bgp5.html#wp1163912

Thanks 

PS: Please don't forget to rate and mark as correct answer if this answered your question.


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

Thank you so much for your reply.

You are welcome to the case:

https://supportforums.cisco.com/discussion/13207666/rd-needs-be-changed-what-protocol-we-can-follow

Hi

You're  welcome. I will take a look on your new post later.

Thanks


Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question