What is the Delay of 10 Gigabit Ethernet?

[Ravi_916]

What is the Delay of 10 Gigabit Ethernet, 100 Gigabit Ethernet?

1. Serial: Bandwidth: 1.544 Mbps, Delay: 20000 ms.
2. Ethernet: Bandwidth: 10 Mbps, Delay: 1000 ms.
3. FastEthernet: Bandwidth: 100 Mbps, Delay: 100 ms.
4. 1 Gigabit Ethernet: Bandwidth: 1 Gbps, Delay: 10 ms.
5. 10 Gigabit Ethernet: Bandwidth: 10 Gbps, Delay: ?
6. 100 Gigabit Ethernet: Bandwidth: 100 Gbps, Delay: ?

[Deepak Kumar]

Hi, 

I never checked on the 100G but 10G interface delay would be: 

DLY 10 usec

It is in the picoseconds.  

[Georg Pauwen]

Hello,

100 Gigabit is 10 msec as well...

HundredGigE0/5/0/24 is up, line protocol is up
Interface state transitions: 1
Hardware is HundredGigE, address is 6219.8864.e330 (bia 6219.8864.e330)
Internet address is 1.24.1.1/24
MTU 9216 bytes, BW 100000000 Kbit (Max: 100000000 Kbit)
reliability 255/255, txload 3/255, rxload 3/255
Encapsulation ARPA,
Full-duplex, 100000Mb/s, link type is force-up
output flow control is off, input flow control is off
--> Carrier delay (up) is 10 msec
loopback not set,
Last link flapped 10:05:07
ARP type ARPA, ARP timeout 04:00:00
Last input 00:08:56, output 00:00:00
Last clearing of "show interface" counters never
5 minute input rate 1258567000 bits/sec, 1484160 packets/sec
5 minute output rate 1258584000 bits/sec, 1484160 packets/sec
228290765840 packets input, 27293508436038 bytes, 0 total input drops
0 drops for unrecognized upper-level protocol
Received 15 broadcast packets, 45 multicast packets
0 runts, 0 giants, 0 throttles, 0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
212467849449 packets output, 25733664696650 bytes, 0 total output drops
Output 23 broadcast packets, 15732 multicast packets
39 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transition