01-22-2012 11:26 PM - edited 03-04-2019 02:59 PM
I am attaching the packet tracer file "Wrong Rip.pkt", in which i have configured networks as in the pic http://i.lulzimg.com/7c8a2d69de.png , The problem is when i remove the network 10.1.4.0 from the scene, everything works perfectly i.e each router can communicate with each other but when its in the design router networks unable to talk... What am i doing wrong???
01-23-2012 12:55 AM
Hi,
for VLSM support and discontiguous networks like in your topology you must use RIP v2 and disable auto-summary.
on all routers:
conf t
router rip
ver 2
no auto
do clear ip route *
then verify all the networks are in the routing table: sh ip route rip
Regards.
Alain
01-23-2012 01:12 AM
I understand this could be problem of Discontinous network, but how it is supposed to be VLSM??
01-23-2012 01:49 AM
Hi,
Yep you're right the mask is /24 everywhere , I answered too fast for the VLSM thing.
Regards..
Alain
01-23-2012 01:51 AM
Thanks..i will read about discontinous networks then..
01-23-2012 02:44 AM
Hi,
Don't forget to rate helpful posts and mark the thread as solved if your problem is resolved.
Regards.
Alain
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide