Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys, Currently I am getting project of conversion of IPv4 network to IPv6. Network running on IPv4 is connected to ISP providing IPv4 Internet. I know NAT-PT would easily do that, but since NAT-PT does conversion, hence defeatin...
Hi All, Here is the scenario which i am usingTASK: I want to block all the data stream destined to 10.10.10.2 which travel from port 80 of http server.I am trying the Extended access list as followsaccess-list 131 deny tcp host 10.10.10.1 eq www host...
I have topology as followsLike shown in the pic, I am using SVI Vlan 70 with IP shown on both of the Switch R1 and R2. R1 is in Active state while R2 is in standby state.The Problem is, R1 is able to ping the IPs, 172.30.70.3 & 172.30.70.1R2 is able ...
1.I know,the port on which BPDU Filtering operates, it disables the incoming and outgoing of BPDU which prevents looping and hence provides security.2.However it also states if any of the portfast port (on which BPDU Filtering is already operating) r...
I am attaching packet tracer file "Routing Rip Example.pkt". in which i connected few routers and configured networks using two classe of IPs, Class C and ClassA all using same subnet mask /24,pis is here http://i.lulzimg.com/1b225f6042.png and the ...
Thanks Matt for your valuable reply and making BPDU filter more clear, however i m still confused with the security part of the BPDU, I mean whats the point of re-enabling the portfast port for STP again, doesn't it sound security vulnerable..For Exa...
