Which device can covert NxT1 into Ethernet?

[news2010a]

Hi,

I was told it is possible to get 2xT1 and convert this into Ethernet via a type of device and deliver to the CPE (router) as Ethernet.

Does this work well?
Which is the device capable of delivering that?

[Marwan ALshawi]

Not sure if there is device like ntu to fo this

But a voice gateway can interface between tdm isdn and ip packet switched network !

Sent from Cisco Technical Support iPhone App

[gerald.suiza]

are you looking for something similar to this?

http://www.blackbox.com/Store/Detail.aspx/1-Port-T1-E1-Ethernet-Network-Extender-Kit/LR0301A%C4%82KIT

or

http://www.rad.com/10/T1-Serial-and-Ethernet-Interface-Converter/3214/#

i would suggest against using that since that device will be additional point of failure..you can use MFT wics supported on your router then bundle them up into a multilink which would be better costwise and maintenance wise.

hth