Hi guys.
I've just installed card C6800-32P10G in my 6506 with 2T supervisor:
But I noticed, that only L2 traffic could be operated via this card and any L3 traffic couldn't.
I made a lab enviroment:
I connected a PC(10.52.201.201/24) directly to this card, and configured access-port and svi(10.52.201.253/24) in the same vlan. And I can't ping the PC with source of the SVI. But I can do transit ping to this PC via this card from another switch.
I connected to this module and checked cef and cef related tables. And all these tables are empty:
hostname-dfc3#show platform hardware cef
--- Hardware Entry(ies) from Earl 1(Default Earl) ---
Codes: decap - Decapsulation, + - Push Label
Index Prefix Adjacency
-EMPTY-
-------------------------------------------------------
hostname-dfc3#show platform hardware cef vpn 0 lookup 10.52.201.201
--- Hardware Entry(ies) from Earl 1(Default Earl) ---
hostname-dfc3#show ip cef
%IPv4 CEF not running
But I have the same switch with the simmilar card and all these tables are full of entries.
I've read the article https://www.cisco.com/c/en/us/support/docs/interfaces-modules/catalyst-6500-series-supervisor-engine-2t/213281-understand-catalyst-6500-s2t-cef-entries.html
And I got that ip cef is automatically turned on in this module and I don't need to configure it.
Could you help to figure out what's happening with this card?
Thanks in advance.
