Hi,
I have two routers connected over the E1 link via serial interface with the default configuration so encapsulation is on Cisco HDLC.
ROUTER1:
!
interface Serial0/0
bandwidth 1544
ip address 172.30.1.21 255.255.255.252
end
ROUTER2:
!
interface Serial0/1
ip address 172.30.1.22 255.255.255.252
no ip mroute-cache
end
What If I change the encapsulation to X.25? Below is the sample configuration:
ROUTER1:
!
interface Serial0/0
ip address 172.30.1.21 255.255.255.252
encapsulation x25
no ip mroute-cache
x25 address 2405005409
x25 map ip 172.30.1.22 2405005410
!
ROUTER2:
!
interface Serial0/1
ip address 172.30.1.22 255.255.255.252
encapsulation x25 dce
no ip mroute-cache
x25 address 2405005410
x25 map ip 172.30.1.21 2405005409
clock rate 128000
dce-terminal-timing-enable
exit
!
Kindly let me know If the solution works?
Regards,
Muhammad Anser Khan