cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
478
Views
0
Helpful
3
Replies

Balancing between two internet channel on the sdwan

dijix1990
VIP
VIP

Can sdwan balance traffic between 2 isps refer from bandwidth?

3 Replies 3

Hi,

For overlay traffic it is load-balanced per hashing result for next-hop.

For DIA traffic, normally it is load-balanced (again, based on hashing result) and NATed to respective interface/pool/loopback based on WAN interface config. You can also have centralized data policy where you set local-tloc for primary DIA exit interface.

HTH,
Please rate and mark as an accepted solution if you have found any of the information provided useful.

but it doesn't depend to bandwidth on the interfaces? I mean if we have two ISP providers:

ISP A - 1Gb

ISP B - 500Mb

you may use "weight" parameter to better load sharing, but it will work for overlay traffic. I've never seen document that describes "weight" for NAT DIA.

HTH,
Please rate and mark as an accepted solution if you have found any of the information provided useful.