Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Can we implement NAT port forwading via different ISP on sdwan?Like this:isp1 - 1.1.1.1isp2 - 2.2.2.2GigabitEthernet0/0/1.1
encapsulation dot1Q 1
ip address 1.1.1.1 255.255.255.0
ip nat outside
GigabitEthernet0/0/1.2
encapsulation dot1Q 2
i...
We bumped into problem with wake on lan on devices c1111x / c8200. WOL works correctly some times (during we have arp) after arp dissapers (or if I clear it) WOL doesn't work.Gi0/0/1.1 - WAN uplink sdwan tunnelGi0/0/0.200 - devices with network 192.1...
I had 5 flow collectors (VMs)vCPU - 12Memory - 128GbHDD - 3.6TbI decided to add 3 data node to use Data StorevCPU - 18Memory - 64GbHDD - 18TbAnd after it one of my collector started to sent message FlowCollector Performance Degraded - OversubscribedI...
I found that Multiple NAT DIA stop working after reloadingMy config is very simpleVpn 10 - 172.25.10.0/24 via nat dia overload (isp1 and isp2 round robin)Vpn 16 - 172.25.16.0/24 via nat dia pool overload (isp1 and isp2 round robin)Service side interf...
Hello I tried to add nat port forward and found out that only one command was addedI changed template for GigabitEthernet0/0/1.1 and after it line was addedip nat inside source static tcp 172.16.1.2 1300 1.1.1.1 1352 vrf 1 egress-interface GigabitEth...
It's command for simulation flow, you can change path via app route / traffic data policy and check it via show policy service-path (or simulate flow via troubleshooting on the Web interface vmanage). You can see which transport interface can be used...
