Hi,
Am new to SDWAN and am trying to configure port forwading on our SDWAN- We have 10 Isr 1061 running IOS-XE.( Vedge, you have range, no issue)
I can't find any way to add range, I would do manually but the ports are in hundreds and there should be a better way of doing it.
We have Phone PBX that needs following port forwading
eg
Please see below for port forward numbers;
Point these to UCP IP Address: 192.168.1.XXX
Point the below to VOIM/VCIM IP Address: 192.168.1.XXX
UDP 20640 – 20895
Please help me- Can't deploy SDWAN without this as This site will be HQ and Hub.
Thank you in advance.
Just been told by Cisco support team that there is no option to do this- Strange
I have to manually add this in router using cli template.