Cisco Sdwan Controll plane not geting UP

[shivakumarAN45992]

Hi Team,

We have deployed the controllers in ESXi and the vEdge router in PNet. We are able to push all templates and configure the devices in vManage, but there are no OMP details on any vEdge routers. Additionally, no vSmart details appear on the vEdge devices when we run the "show control connections" command, i checked the details like basic configuration(certificate,site-id,sys ip,organizations)unable to resolve the issue.

I have attached the details of all controllers and routers below. Please help me resolve this issue.

[Kanan Huseynli]

Hi,

configure sp-organization-name cool  on all controllers as well.

You may check the issue by running "show control connection-history" command.

[shivakumarAN45992]

Hi,

i have configured the same on all controllers and vedge routers, but still same.

[Kanan Huseynli]

I also asked for control history output, share it

[shivakumarAN45992]

Hi,

Please find the logs,

[MHM Cisco World]

there are many show 
can you share last state one show connect history 

MHM

[MHM Cisco World]

also from vedge 
ping vbond <<- FQDN of vbond
ping ip <vmanage> source interface <vpn 0 interface>

MHM

[shivakumarAN45992]

Hi,

Please find logs,

we are using ip for vBond not fqdn,

10.80.24.194 is vBond, 10.80.24.193 is vSmart and 10.80.24.192 is vManage

[MHM Cisco World]

sorry are there two vmanage ? one .192 and .193 ?

MHM

[shivakumarAN45992]

Hi,

Only one vManage .192 ,

.193 is vsmart 

[MHM Cisco World]

In edge 

Show control local-proper

Share this if yoh can

In vbond 

Show orchest connection-history 

MHM

[shivakumarAN45992]

please find the sh control connections-history output

[SamuelGLN]

Hi @shivakumarAN45992,

Based in your logs you've a DISTLOC error and the root cause can be the lack of color configuration inside tunnel interface on vSmart. Remember that TLOC is represented by three-tuple, consisting of system IP, link color and encapsulation. 

DISTLOC    - TLOC Disabled. 

 Best regards
******* If This Helps, Please Rate *******

[MHM Cisco World]

Are this issue solved 

MHM

[Kanan Huseynli]

Strange, vedge does not initiate control connection to vsmart even.

Share show control local-properties from vedge