Solved: Re: Cisco SDWAN Controller with two transport vpn

lazuardinurfaiz1503 · ‎07-06-2020

Hi all.

Is it posible to deploy sdwan controller with two transport vpn / vpn 0 ? Is there any documentation about this? I cannot find any in sdwan controller, only in sdwan vedge with two vpn 0.

Thank you.

Best regards,

Lazuardi Nurfaiz

Kanan Huseynli · ‎07-09-2020

Hi,

looks like there is no such configuration. I tested in vBOND it accepts 2nd interface (with tunnel config). But since vBOND is vEDGE actually, it may be just cosmetic config.

vSMART and vMANAGE have 2interfaces only (one for mgmt , one for control).

Regards,

HTH,
Please rate and mark as an accepted solution if you have found any of the information provided useful.

View solution in original post

Kanan Huseynli · ‎07-09-2020

Hi,

looks like there is no such configuration. I tested in vBOND it accepts 2nd interface (with tunnel config). But since vBOND is vEDGE actually, it may be just cosmetic config.

vSMART and vMANAGE have 2interfaces only (one for mgmt , one for control).

Regards,

HTH,
Please rate and mark as an accepted solution if you have found any of the information provided useful.