Escape Sequence on Cisco C8000V IOS-XE SDWAN Router

[muthumohan]

Hi All,

I am unable to stop the traceroute in between on this router. What is the "escape sequence" to get out of traceroute outputs?

Ctrl-shift-6 and Ctrl-shift-6 x does not work.

Also, the interface names to be case sensitive on this platform. It gets confused between GigabitEthernet2 and gigabitethernet2. Is that so? Very annoying!

Regards,

Mohan

[Torbjørn]

What version are you using? Just tested on a Cat8000v running 17.09 and ctrl + shift + 6 worked as it should.

The configuration is indeed case-sensitive for interface names... Which I agree is very annoying.