cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
258
Views
0
Helpful
1
Replies

IPv4 DIA & IPv6 DIA - over the same transport interface

jgeralsky
Level 1
Level 1

Hello ,

We would run dual stack (IPv4 & IPv6) at service side, and also we would run dual stack (IPv4 & IPv6) on the transport internet interface(underlay), on SD-WAN router. 

Is it possible to enable IPv4DIA (NAT44) and IPv6 DIA (NAT66) via the same transport internet interface(underlay) ? 
If so, is there any official Cisco documentation related to this specific topic ? 
If so, are there any restrictions ? 

I think, it should be possible, but I didn't find any related information related to this topic.

Many thanks,
Jan

1 Reply 1

Review Cisco Networking for a $25 gift card