cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1166
Views
0
Helpful
6
Replies

SD-WAN Bulk API: Data Refresh Frequency

Prodrick
Level 1
Level 1

For the SD-WAN Bulk API, when one calls state and statistics endpoints, how delayed are the results, i.e. how often are the backend data updated?

Thanks

https://developer.cisco.com/docs/sdwan/#!bulk-api

6 Replies 6

stephli2
Cisco Employee
Cisco Employee

Hi Prodrick,

which specific endpoints are you using?

Here are a few from this reference: https://developer.cisco.com/docs/sdwan/#!bulk-api/bulk-api

State

Statistics:

 

If i recall, Bulk API state endpoints return data that is updated every 30 seconds. The statistics endpoints return data that is updated every 5 seconds. This means that the results of a call to a state endpoint may be up to 30 seconds old, and the results of a call to a statistics endpoint may be up to 5 seconds old.

Starting from Cisco SD-WAN Release 20.6.1, Cisco SD-WAN Manager supports below API limits:

  • API Rate-limit: 100/second

  • Bulk API Rate-limit: 48/minute

Please mark this as helpful or solution accepted to help others
Connect with me https://bigevilbeard.github.io

Prodrick
Level 1
Level 1

I am looking for an official reference document that specifies the refresh frequency 

If its not in the https://developer.cisco.com/docs/sdwan/#!bulk-api i would not know where to suggest you look. If you get no reply here i would suggest raising this with TAC.

Hope this helps.

Please mark this as helpful or solution accepted to help others
Connect with me https://bigevilbeard.github.io

Prodrick
Level 1
Level 1

Hoping someone from Cisco will respond here with a definitive answer.

Review Cisco Networking for a $25 gift card