05-27-2020 10:06 AM
Hello. I have need to create a weighted route via templates on my cEdge Routers. Does anyone know if this option will be available at some point in the future? In CLI mode it works fine. example:
ip route vrf 10 1.2.3.4 255.255.255.255 192.168.240.1
ip route vrf 10 1.2.3.4 255.255.255.255 192.168.199.1 200
Thanks in advance.
Solved! Go to Solution.
06-23-2020 11:08 PM
Hi,
You shouldn't have any trouble pushing a floating static route from vManage to a cEdge device.
Using the VPN Template on the service vpn, from the IPv4 Route section, enter the prefix, press next hop, add ip address of first next hop, then press "+ add next hop", enter 2nd prefix and add a distance (weight).
press "add" to save both prefixes.
the example below will produce 2 static routes.
ie
06-23-2020 11:08 PM
Hi,
You shouldn't have any trouble pushing a floating static route from vManage to a cEdge device.
Using the VPN Template on the service vpn, from the IPv4 Route section, enter the prefix, press next hop, add ip address of first next hop, then press "+ add next hop", enter 2nd prefix and add a distance (weight).
press "add" to save both prefixes.
the example below will produce 2 static routes.
ie
06-24-2020 06:32 AM
this doesn't work. If you look at the config after you push the template you get someting like this. note, no weights these are equal routes.
the second statement should have a 100 tacked on to the end of it. If I do this from the cli, it works just fine. But we want to use the templates.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide