- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2025 09:28 PM
Hello All,
SDWAN-Edge1(config)# ip ssh client algorithm mac ?
^
% Invalid input detected at '^' marker.
SDWAN-Edge1(config)# ip ssh server algorithm mac ?
^
% Invalid input detected at '^' marker.
I am unable to change the mac in the SD-WAN Router, when i do a show run all, i am able to see
ip ssh server algorithm mac hmac-sha2-256-etm@openssh.com hmac-sha2-512-etm@openssh.com
ip ssh client algorithm mac hmac-sha2-256-etm@openssh.com hmac-sha2-512-etm@openssh.com
How can i change this?
Solved! Go to Solution.
- Labels:
-
SD-WAN Architecture
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-12-2025 07:13 PM
TAC has confirmed in controller mode there is no way to change the Message Authentication Code.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2025 10:47 PM
Can change this is autonomous mode, without any problems
test(config)#ip ssh server algorithm mac hmac-sha1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-12-2025 07:13 PM
TAC has confirmed in controller mode there is no way to change the Message Authentication Code.
