10-14-2021 03:21 AM
Hi Friends,
Please help me to understand the requirement of the tunnel interface to communicate between SDWAN Controllers.I mean for vManage,vSmart and vBond.
Thanks,
Manoj
10-20-2021 03:35 AM
Hi,
you should have IP address, respective routes in VPN 0 (in most case, default route), allowing services (https/stun/netconf etc) and color.
Color design is specific topic, better to read in Cisco SDWAN CVD. But it is , in general, not limited with this. You should configure system parameters, respective underlay connectivity (routing, NAT), controller certificates. If you are new in SDWAN, better to read the whole CVD.
https://www.cisco.com/c/en/us/td/docs/solutions/CVD/SDWAN/cisco-sdwan-design-guide.html
Regards,
10-21-2021 12:08 AM
Hi Kanan
Can you help me to troubleshoot my tunnel connection at thread https://community.cisco.com/t5/sd-wan-and-cloud-networking/how-to-troubleshoot-tloc-tunnel-connection/m-p/4489582#M3763
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide