cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Choose one of the topics below for SD-WAN Resources to help you on your journey with SD-WAN

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.

836
Views
0
Helpful
3
Replies
csdinesh18
Beginner

vManage installation in Active/Standby state

Could someone please help with the steps to configure vManage in Standby mode? we're using the version 19.2.3

1 ACCEPTED SOLUTION

Accepted Solutions

3 REPLIES 3

Hi Dinesh ,

Have you got solution .

I am looking for same to deploy 

Hi Dinesh , 

I checked this document but was not able to succeed , if you can connect with me once would be great helpful . 

 

in this document it is given at a time a DR we need to upload backup from primary Vmanage i understood this . 

 

my Confussion is do we need to add any cluster or disaster recover for Vmanages . 

------------------------------------------------------------------

 

2. Verify that all services are running on the standby vManage NMS. From the CLI, use the request nms all status command.
3. On the standby vManage(s), navigate to Configuration ► Devices ► Controllers. Verify that the page displays all vManage(s)
for active and standby systems.

 

iam able to see only one vmanage in standby vmanage . 

 

If your comfortable can we connect any remote or  phone .