10-09-2020 07:36 AM
Could someone please help with the steps to configure vManage in Standby mode? we're using the version 19.2.3
Solved! Go to Solution.
07-15-2021 09:11 AM
The steps are available in the below link.
We did it successfully.
07-14-2021 09:49 PM
Hi Dinesh ,
Have you got solution .
I am looking for same to deploy
07-15-2021 09:11 AM
The steps are available in the below link.
We did it successfully.
07-15-2021 10:16 AM
Hi Dinesh ,
I checked this document but was not able to succeed , if you can connect with me once would be great helpful .
in this document it is given at a time a DR we need to upload backup from primary Vmanage i understood this .
my Confussion is do we need to add any cluster or disaster recover for Vmanages .
------------------------------------------------------------------
2. Verify that all services are running on the standby vManage NMS. From the CLI, use the request nms all status command.
3. On the standby vManage(s), navigate to Configuration ► Devices ► Controllers. Verify that the page displays all vManage(s)
for active and standby systems.
iam able to see only one vmanage in standby vmanage .
If your comfortable can we connect any remote or phone .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide