Hello Everyone. Hope you all must be doing fine. Thanks again for the incredible response on my previous blog “”. As promised I have come with this blog that talks about Software VPN client logs and some of the common issues.
So are you ready for this new blog?
Here we go (Please click the images to enlarge them.)
1. Software VPN Client Logs
To launch VPN client, please refer the following steps---
2. Software VPN Client Logs Initial Contact
So you will notice the following logs when VPN client initiates the connection.
Hello, Bit of a while since I've posted here, need some advice. I'm revisiting the configuration for an active/standby ASA HA setup, and I don't think I've ever totally nailed a proven, recommended resilient topology when thinking about th...
I have tunnels on a cisco router 4221but i wanted traffic from 1 tunnel to be Natted and leave the rest,.i used a route map on a static NAT. but when i enable the route map on the ip nat other tunnels pass traffic through very well, but refuses on the oth...
Hi Folks, I have some problems and confusion with IPSec phases and Ike version and relationship with fqdn.I can set up tunnels but I'm not sure how troubleshootingIf you have any resources or documentations for that please update me
Looking for recommendations on guest/certificate issues on our ISE self registration portal, my certificate knowledge is pretty limited and just getting into using certificates.This is only for guest users and contractors to avoid getting annoying certifi...