We recent added 2 new Blades Server B200m4 in our running environment. After initializing and power up (VMware Hypervisor 6.0) when I check the VNICs availability for these 2 Blades, there are only 2 VNICs inside New Blades but for old Blades there are around 10 VNICs.
I am aware that in Blades Server these are Virtual NICs and some where in UCS Manager we need to select additional VNICs.
Can some one provide complete steps to adding further VNICs for new Blades?
Good afternoon Friends, these days I was accessing the DNAC manager and my surprise is that I did not have access, after a basic analysis I observed that the equipment was operational, but without being able to access it via DNA GUI (browser) I also ident...
Today we are going to talk about how to configure backups in the Cisco ACI APIC Dashboard. As you might know APIC is a UCS based CIMC controller and we can check the configuration backups on the Cisco ACI APIC Dashboard. Remember that the HA solution mus...
Listen: https://smarturl.it/CCRS9E14 Follow us: https://twitter.com/CiscoChampion
Organizations are undergoing digital transformation like never before. Global spending on digital transformation of business practices, products, and organization...