cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
425
Views
0
Helpful
1
Replies

Board Controller Firmware Mismatch B200 M3

acowles-eplus
Level 1
Level 1

Hey guys,

 

I've got several UCS B200 M3 blades, and recently had a problem with one that required a board replacement.

 

On all of the blades I have running 2.2(1d) but what I find odd is that all of the blades have Board controller's at version 13.0, whereas the replacement is running 11.0.

 

As best as I can tell the 2.2(1d) server software package contains 11.0, so I don't understand where 13.0 comes from on all the other blades (I surmise it was shipped this way as the backup version is 2.2(3c) and perhaps a downgrade was performed upon install)

 

As 11 is the version shipped with 2.2(1d) does it seem likely that I need to upgrade the board controller to 13?

 

 

 

1 Reply 1

Walter Dey
VIP Alumni
VIP Alumni

Don't worry, it is a well known issue; One cannot downgrade Board Controller Firmware from Version 13 to 11.

It will not cause any Problems !

Review Cisco Networking for a $25 gift card