Server Networking

Hi guys,I hope you can help me with the following, i've tried search with no luck so far. The Scenario:We (my Company) is managing a DataCentre-environment, with UCS, VMWare, Nexus 1000v etc etcThe VCenter-server has an IP-address in one network that...

Hi,   I'm planning to upgrade Nexus 5548UP (no L3 services) from 5.2(1)N1(6)  to 7.0(5)N1(1). Is this upgrade path vaild? or is there any intermediate version; also advise if ISSU is possible. Regards, Navin RK

Hi all,Need some suggestion. Has an UCS environment, two FIs one Blade Chassis 6 Blade Servers, 2 Servers with 256Gig Mem and 4 with 128Gig Mem.2 Servers with 128 and two servers with 256 Gig working correctly from the beginning. Then we tried to add...

All,While researching UCSM server pool policies it was noted that to build one you usually construct them via:1. Define a Pool2. Define a Server Pool Policy Qualification3. Tie the two above together with a Server Pool PolicyThe documentation states ...

Dears ,any one can help me in connecting the followingBNT 10 fabric switch with Nexus 7000 using port channelhow to configure it as port channel in BNTdesign as attached 

Hi all,I'm trying to connect in FCoE mode a UCS 220 M4 + VIC 1225 card to a NEXUS 5596.1 - I have enabled the FCoE feature => feature fcoe2 - I have configured vHBA card with default vlan 900 on UCS3 - I have created vlan 900 + vsan 900 on the NEXUS4...

Good morning, I am trying to find why our N2K are sending pause frame to the host when to uplink is not congested. fex is a 2232N5K running 7.1 sample interface counters : Ethernet109/1/2 is up  Hardware: 1000/10000 Ethernet, address: d4d7.481c.4143 ...

We implemented 6 blades B200-M3, 2 FI 6248UP, SAN SW:brocade and EMC VNX 5200 storage ESXi 5.5 free edition installed to the blades and installed VMs when we tested the HA between 2 FI, the VMs were pingable but some VMs dropped 1 ping and other drop...

Hello Team,  I would like to seek your assistance in configuring a Nexus 3048 switch, I have inserted a FCOE to its 4 SFP ports, however upon enabling the feature fcoe, I have received an error. I would like to know if the Cisco 3048 switch supports ...

When we tested the HA between 2-FI 6248UP and we used the ping operation to insure that the management IPs are pingable then after we reboot the primary FI, the subordinate FI management IP was pingable but the cluster IP  took around 10-15 min to re...

Could please share the URL for UCS server ordering guide.