Why doesn't cdp neigh show both ports like 1/1 and 1/2 of the port-channel other than mgmt0? I have the same cdp output on the other N5k
N5K-EDGE2-DC(SSI13500AD5)mgmt0 145 S I s N5K-C5010P-BF mgmt0
N5K-EDGE2-DC(SSI13500AD5)Eth1/2 152 S I s N5K-C5010P-BF Eth1/2
----------------------------------------------------------------------
interface port-channel200
description ****TO-N5K-EDGE2-DC PORTS 1 and 2****
switchport mode trunk
vpc peer-link
spanning-tree port type network
logging event port link-status
logging event port trunk-status
interface Ethernet1/1
description ****TO-N5K-EDGE2-DC PORTS 1 and 2****
switchport mode trunk
untagged cos 0
channel-group 200 mode active
interface Ethernet1/2
description ****TO-N5K-EDGE2-DC PORTS 1 and 2****
switchport mode trunk
untagged cos 0
channel-group 200 mode active
N5k-Edge1-DC# sh int por 200
port-channel200 is up
Hardware: Port-Channel, address: 000d.ecf6.8e09 (bia 000d.ecf6.8e09)
Description: ****TO-N5K-EDGE2-DC PORTS 1 and 2****
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
full-duplex, 10 Gb/s
Beacon is turned off
Input flow-control is off, output flow-control is off
Switchport monitor is off
Members in this channel: Eth1/1, Eth1/2
