Cisco Nexus C92160YC-X Dot1Q

[sander64]

Hello,

I have multiple C92160YC-X  but it looks like this one does not support QinQ / Dot1Q tunnel ports is this correct? 
i cannot find option to enable this feature, or is this maybe a firmware issue?

We have also C3064PQ which do support this function, i thought if n3k does then n9k does also, but this is not the case?

I have searched on the internet where they say that 9000 series can do Dot1q / QinQ but i cannot enable or set this mode on an interface.

Kind regards,

Sander

[Flavio Miranda]

@sander64 

It is supported as we can see here on this document. But, check on the document "Guidelines and Limitations" to see if you fall in any of the limitations.

 Nexus also have the command "show feature".

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/interfaces/configuration/guide/b_Cisco_Nexus_9000_Series_NX-OS_Interfaces_Configuration_Guide_7x/b_Cisco_Nexus_9000_Series_NX-OS_Interfaces_Configuration_Guide_7x_chapter_0110...

[sander64]

I don't see it in feature list, i see in you link the following note:

Q-in-Q tunneling is not supported on the following Application Spine Engine 2 (ASE2) and Application Spine Engine 3 (ASE3) based Cisco Nexus switches:

• ASE2 - N9236C, N9272Q, N92304QC, and N92300Y

• ASE3 - N92160YC

Is this the same as C92160YC-X?  because that would meen it is not possible?