I created to RAID-1 as virtual hard-drive in order to install Vmware and later cisco NCS software at ciscı C220 M3. I followed the all the procudure then l was succesfull to istallation of softwares. I just a small problem that when ı rebooted the server my wmware was not working automaically. Later on ı try to change boot order in order to check my virtual hard-drive. Maybe ı made some mistake the boot order because later the server was asking to me update of CIMS driver and etc (the server CIMS software is 1.3d and bakcup 1.3). When ı tried to update CIMS somehow server was crashed. I couldnt see nothing on the monitör also mause and kepboard wasnt working.
I checked the procedure document ans somelink in this webpage.
Even i couldnt understand some point. I found the recevory.cap file but whic directoy ı need put ? For example my usb-drive letter is F: could you confirm which is correct director
To recovery of bios just recovery.cap file is not or not ?
I copy the many possiblity my usb.drive somehow the server found the recovery.cap . Now below message was written on the screen but during the 1 day but the bios is still not updated
System would restart with recovered image after a few seconds...
What ı am doing wrongly i couldnt understand
Thanks for support
i was hoping you have found a solution for this problem for i have the same now.
i have followed to two procedures to boot with recovery.cap with thumb usb, it transfers the data to controllers, and when it finishes i get to the same screen you do :" found a valid recovery file.. transferring to controller
system would flash the bios image now..
system would restart with recovered image after few seconds.. "
this screen just freezes even after an hour still nothing.
thank you in advance!
Hi srachma, I can't find response for your problem, and I have the same one with a ucs-c220-3m.
I saw too that your problem was reported 4 months Ago, then I suposse that you found a solution for this. Isnt? If this is the case, Could you please share the actions to solve it? My email is firstname.lastname@example.org
Thanks in advance
Hi Yuksel, I can't find response for your problem, and I have the same one with a ucs-c220-3m.
I saw too that your problem was reported 9 months Ago, then I suposse that you found a solution for this. Isnt? If this is the case, Could you please share the actions to solve it? My email is email@example.com
Thanks in advance
Hi everyone, I have the same problem my server is ucs-c240-m3 I tried recover with various recovery.cap files but that doesn't work, Have someone fix it ?