03-14-2016 10:37 AM
Dear friends, my pair of 6248UP simply got inoperative after a power failure. Power LEDs run as expected but I got no signal on front panel at all. I mean, no frontal LEDs are lit.
Is there any test I can make or nothing more than a RMA?
Thank you!
03-14-2016 06:10 PM
Did you try powering it on. If that doenst help then nothing much you can do it would be hardware issue.
03-14-2016 11:56 PM
Did you connect the console ? do you see anything ? is the cluster HA ready ?
If you don't see anything please open a TAC case.
03-16-2016 04:55 AM
Walter,
Console is unresponsive. I'm realizing there's nothing to do but open the TAC case.
03-16-2016 04:54 AM
InayathUlla,
Yes, I resetted them. The LEDs don't come up.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide