Monitor trunk links on nexus 9k's with Cisco Prime

[DAVID]

I am using Cisco PI to monitor and backup my nexus 9000's but can't seem to get PI to show the interface utilization of the links on the 9k's

Pi shows "check if SNMP Polling is enabled" in the interface TX and RX utilization.  Exactly where in PI is this addressed?  I have the the Nexus 9k's in a site and the trunk links in a port group

[Rick1776]

See the following configuration guide.

https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-1/user/guide/pi_ug/setup_monitor.html#83947