03-02-2011 06:05 AM
Hi All,
can i connect single N4K with Port channel to 2 X FEX-2232, when each 2232 goes only to single N7K ?
is there any limitationes regarding this type of connectionen ?
thanks.
03-02-2011 07:08 AM
The ports on the 2232 will be err-disabled since the N4K is a switch and it will send out BPDU.
You should consider to connect the N4K to the N7K directly.
HTH,
jerry
03-02-2011 07:52 AM
Ok Thanks,
Should it make a difference if i will connect single N4K with Port-Channel to single FEX-2232 ?, in that case i do not need STP.
03-02-2011 08:31 AM
Still going to be the same. Unless you disable STP on N4K so it is not sending out BPDU which is very risky and it can introduce a loop. Bottom line, don't connect the N4K to the 2232.
Regards,
jerry
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide