11-30-2011 11:58 PM
Hi there,
I've got the follwoing problem, I would like to enable the QoS policy statistics on my Nexus 5010 running firmware 5.0(3)N2(2a).
This is where I am at:
nexus# show policy-map interface
Global Statistics status : enable
Ethernet1/1
Service-policy (qos) input: default-in-policy
policy statistics status: disabled
...
Service-policy (queuing) input: default-in-policy
policy statistics status: disabled
...
Service-policy (queuing) output: adapted-out-policy
policy statistics status: disabled
As you can see I managed to enable the statistics globally via "(config)# qos statistics" but I don't have any clue how to enable the statistics for every service-policy on every interface. The config guides and examples already had them enabled but didn't mention the corresponding command(s).
I really hope someone can help me on this.
Thanks in advance!
Greetings!
12-01-2011 06:11 AM
Hi
This feature is not currently supported on n5k devies.
You can use "show queuing interface Ethernet x/y"
12-01-2011 11:23 PM
Hi,
thanks for answering. (How) Do the policy statistics status and the "show queuing interface e x/y" information differ?
Is it planned to support the policy statictics status with a later NX-OS release?
And what I really don't understand, why is it possible to enable the policy statistics globally when I can't see anything afterwards? What is this command good for in the current release?
Looking forward to get more answers ;-)
Thx again!
02-01-2012 06:58 AM
Currently most adequate output has
show queuing interface e x/y
It's planned to support "show policy-map interface" in future releases. But no additional info is available.
HTH,
Alex
11-29-2017 12:28 PM
hello Colleagus
Last entry in this mail chain forum is 5 years old. I wasnt successful to find any more actual forum on internet.
I'd like to ask if is there already any version which support it?
we use N5K system version: 7.0(6)N1(1) and have the same issue as mentioned upper.
11-07-2018 01:44 AM - edited 11-07-2018 01:46 AM
Still the same issue here. Any Updates on the mentioned feature support?
show queuing interface does not show any information regarding packet Marking.
Version is:
7.0(8)N1(1)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: