Anyone ever seen this before? Trying to understand why the port error disabled.
2011 Jan 18 11:53:09 MTWDAVDC1BLDB9001 %ETHPORT-2-IF_DOWN_ERROR_DISABLED: Interface Ethernet1/1 is down (Error disabled. Reason:requested by sap: MTS_SAP_DCX, req down_type: 2, req down_reason: 222 )
MTWDAVDC1BLDB9002# sh int eth1/1
Ethernet1/1 is down (DcxMultipleMSAPs)
Hardware: 1000/10000 Ethernet, address: 0027.0d23.4d8d (bia 0027.0d23.4d8d)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA
Port mode is trunk
full-duplex, 10 Gb/s, media type is 10g
Input flow-control is off, output flow-control is off
Rate mode is dedicated
Switchport monitor is off
Last link flapped 1d03h
Last clearing of "show interface" counters never
1 minute input rate 0 bits/sec, 0 packets/sec
1 minute output rate 0 bits/sec, 0 packets/sec
Rx
153349455 input packets 143221479 unicast packets 3730739 multicast packets
6397237 broadcast packets 0 jumbo packets 0 storm suppression packets
66448449173 bytes
Tx
328643307 output packets 90031378 multicast packets
113132871 broadcast packets 12877361 jumbo packets
62121338327 bytes
0 input error 0 short frame 0 watchdog
0 no buffer 0 runt 0 CRC 0 ecc
0 overrun 0 underrun 0 ignored 0 bad etype drop
0 bad proto drop 0 if down drop 0 input with dribble
1416 input discard
0 output error 0 collision 0 deferred
0 late collision 0 lost carrier 0 no carrier
0 babble
0 Rx pause 0 Tx pause
8 interface resets
