We are trying to activate a link between a Cisco 2851 and a AS400 (iSeries)
snasw cpname PRUEBA.SNASW
snasw port HPRLOOP hpr-ip Loopback0
snasw pdlog information
snasw dlctrace format analyzer
snasw event dlc
interface Loopback0
ip address 192.168.104.31 255.255.255.0
By debuging snasw we get the following messages, an finally the tipical mismatch XID error or retry count
debug snasw dlc
000206: Jun 13 10:38:16.152 MET: 255 @I000002 Out sz:0 XID Null
000207: Jun 13 10:38:16.152 MET: 256 @I000002 In sz:80 XID 3 PN PRUEBA.D0612AAA xid:
000208: Jun 13 10:38:16.152 MET: 257 @I000002 Out sz:100 XID 3 PN PRUEBA.SNASW xid:FFF00000
000209: Jun 13 10:38:16.156 MET: 258 @I000002 In sz:113 XID 3 NP PRUEBA.D0612AAA xid:
000210: Jun 13 10:38:16.156 MET: 260 @I000002 Out sz:131 XID 3 NP PRUEBA.SNASW xid:FFF00000
000211: Jun 13 10:38:16.160 MET: 261 @I000002 In sz:113 XID 3 NP PRUEBA.D0612AAA xid:
000212: Jun 13 10:38:16.160 MET: 262 @I000002 Out sz:131 XID 3 NP PRUEBA.SNASW xid:FFF00000
000213: Jun 13 10:38:31.156 MET: 263 @I000002 In sz:113 XID 3 NP PRUEBA.D0612AAA xid:
000214: Jun 13 10:38:31.160 MET: 264 @I000002 Out sz:131 XID 3 NP PRUEBA.SNASW xid:FFF00000
000215: Jun 13 10:38:46.157 MET: 265 @I000002 In sz:113 XID 3 NP PRUEBA.D0612AAA xid:
000216: Jun 13 10:38:46.157 MET: 266 @I000002 Out sz:131 XID 3 NP PRUEBA.SNASW xid:FFF00000
000217: Jun 13 10:39:01.157 MET: 267 @I000002 In sz:113 XID 3 NP PRUEBA.D0612AAA xid:
000218: Jun 13 10:39:01.157 MET: 268 @I000002 Out sz:131 XID 3 NP PRUEBA.SNASW xid:FFF00000
000219: Jun 13 10:39:01.157 MET: %SNASW-3-CS_LOG_6: PROBLEM - 9 - XID protocol error during activation exchange
XID protocol error during activation exchange
Sense code = 0x083E0000
Port name = HPRLOOP
LS name = @I000003
Adjacent CP name = PRUEBA.D0612B9B
Remote MAC+SAP address =
Byte offset = 0x00
Bit offset = 0x00
The Cisco is running c2800nm-adventerprisek9_sna-mz.124-25f.bin
There is a way to change the XID in the exchange between the Cisco and AS400?
