SNMP response interface

[lomine]

Hi all,

I have a problem in SNMP configuration on routers 2500, 2600 and 3600 series using IOS version 12.1(20).

The SNMP management are performed using loopback interface, but the router don´t reply to SNMP request (udp 161) using the loopback source interface.

I use the command snmp-server trap-source loopback 0, but it´s work only to SNMP trap (udp 162).

Can anybody help me ?

Tks.

[Craig Norborg]

Hmm... This works for me, How have you determined that this is not working right? Have you looked into upgrading your IOS further? Have you enabled SNMP debugging?

[chuggler]

We have a similar problem, did you find a solution?

We try to snmp get through a ipsec tunnel to the inside interface of a router. The router send an answer from the outside interface and this doesn't get back through the IPSEC tunnel.

Thanks.