- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-26-2017 09:41 PM - edited 03-01-2019 01:40 PM
Hi,
I'm working on a ACI setup, and try to enable LLDP for UCS discovery. However there is no enable option in CIMC. I tried documentation and it says "This option is available only on some UCS C-Series servers."
I wonder if I need to upgrade firmware to enable it, or switch the VIC card? Or do we have to get some other UCS servers for this? Thanks.
Solved! Go to Solution.
- Labels:
-
Other Server Networking
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-27-2017 04:28 PM - edited 09-27-2017 04:32 PM
What kind of C-series rack and network card are you using? In some of the older firmware the option was only available via CLI on the VIC similar to:
https://supportforums.cisco.com/legacyfs/online/attachments/document/files/apic-vic-lldp-fn.pdf
Further info:
Supported Feature in Release 1.5(4e)
A new CLI command lldp with the arguments enabled and disabled has been added to the adapter scope. The command enables you to enable and disable LLDP for Cisco adapters
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-27-2017 04:28 PM - edited 09-27-2017 04:32 PM
What kind of C-series rack and network card are you using? In some of the older firmware the option was only available via CLI on the VIC similar to:
https://supportforums.cisco.com/legacyfs/online/attachments/document/files/apic-vic-lldp-fn.pdf
Further info:
Supported Feature in Release 1.5(4e)
A new CLI command lldp with the arguments enabled and disabled has been added to the adapter scope. The command enables you to enable and disable LLDP for Cisco adapters
