I'm trying to reset ASR9901, but the options (2 & 3) doesn't seem to work.
When I reset after change, it boots as normal, ignoring nothing. Also I have to give the option -s (soft) -h (hard) for the reset command. Is there a different procedure for ASR9901?
Booting IOS-XR 64 bit Boot previously installed image - Press Ctrl-c to stop S Please select the operating system and the boot device: 1) Boot to ROMMON 2) IOS-XR 64 bit Boot previously installed image 3) IOS-XR 64 bit Mgmt Network boot using DHCP server 4) IOS-XR 64 bit Mgmt Network boot using local settings (iPXE) (Press 'p' for more option) Selection [1/2/3/4]: 1
Hello All, I am trying to learn BGP EVPN on cisco CSR 1000v routers. R2 and R3 are cisco CSR1000v. And R1 and R4 are cisco IOS. With the below configuration, I see route type-5 but I do not see route type-2 and route type-3. What should be the config...
HI Expert Our A9K have MODE80 Card(insert daughter Card A9K-MPA-4X10GE） and A9K-8T-L LC, We configure mpls ldp on these Line cards ,but only interface of A9K-8T-L can be establish mpls ldp neighbor, we don't get any mpls ldp info...