Article ID:1925
Objective
The article explains how to access web-based setup page of PAP2T.
Applicable Devices
• PAP2T Phone Adapter
Access PAP2T Web Interface
Step 1. Check the physical connectivity of devices as per the connectivity diagram shown above.
Step 2. To determine the IP address of PAP2T, press four asterisk (*) keys on your analog phone attached to PAP2T and then press option 110 followed by pound (#) key.
Note: If the router has a DHCP server in built in it, configure the IP address of PC connected to router in the subnet 192.168.1.0/24. Your PC gets an IP address in the subnet through the DHCP.
Step 3. Open a web-browser and enter IP address of PAP2T in address bar then press enter.
Step 4. The User Login is user and Admin Login is admin. By default, passwords are not set.