Article ID:1790
Objective
Real-Time Remote Replication (RRTR) Server is a software service used in Network Attached Storage (NAS) application servers. It helps to provide file sync features on data encryption, compression and file filtering. These features improve the performance and efficiency of synchronizing files routed through the Internet. The RTRR Server paves way to perform one-way synchronization from the local NAS to a remote server or from a remote server to a local NAS.
The objective of this document is to explain how to configure the RRTR Server on NSS300 Smart Storage Series devices.
Applicable Devices
•NSS322
•NSS324
•NSS326
Configuration of RRTR Server
Step 1. Log into the web configuration utility and navigate to Application Servers > Backup Server > RRTR Server. The Backup Server page opens:
Step 2. Check the Enable Real-time Replication Server field to enable Real-time Remote Replication between NAS and remote server.
Step 3. Enter the port number for remote connection in the Port Number field. The default port number is 8899.
Step 4. Configure the following fields in the Password area:
• Password — Enter the password for the remote server in this field.
• Verify Password — Re-enter the password for the remote server.
Step 5. Choose a radio button in the Network Access Protection area.
The available options are described as follows:
• Allow all connections — Click this field to allow all connections to NAS.
• Allow connections from the list only — Click this field to allow only the IP addresses listed in the table to connect to NAS. It is to be noted that if the list is empty, all the connections to the server will be allowed.
Step 6. Click Add to add an IP address or network domain. This button is available if you click Allow connections from list only. Clicking this button will open a new page.
Step 7. Choose IPv4 or IPv6 from the IP Address Format drop-down list.
Step 8. Click the Single IP address radio button to add a single IP address. Enter the IP address in the IP address field.
Step 9. Click the Specify IP addresses of certain network by setting IP address and netmask button to add an IP address and subnet mask. Enter the IP address in the IP field and the subnet mask in the Subnet Mask field. The default subnet mask is 255.0.0.0
Step 10. From the Access right drop-down menu, choose Read/Write access or Read Only access.
Step 11. Click Finish to complete adding the IP address. The IP address is added to the table.
Step 12. Click Delete to delete an IP address from the table.
Step 13. Click Apply to save RRTR server settings and reboot the NAS.